Sign kit : 5 frame parts, 2 logo plates

Frame Accessories : 4 short screws, 4 long screws, 4 adjusters, 1 hex wrench

Logo Plate Accessories : 4 strips of strong double-sided adhesive tape

From left to right: Frame [A] x 2, Frame [B] x 2, Frame [C] x 1

From left to right: adjuster, long screw, short screw, hex wrench

2 logo plates (with and without printing)

4 pieces of strong adhesive double-sided tape

How to install

①Attach two pieces of double-sided tape to the round indentations at the top of Frame [C]. After peeling off the backing, affix the logo plate. (Press firmly for about 30 seconds.) ※Attach one logo plate on each side (front and back).

②Attach four adjusters to the four holes on the bottom of Frame [A]. ※Install in the area indicated in red in the photo below.

Insert them into the holes on the bottom.

Tighten them fully. ※After installation, adjust the height of the adjusters as needed.

③Attach Frame [B] to the bottom of Frame [A] using the long screws and hex wrench in four places.

※Install in the area indicated in red in the photo below.

Install the screws with the side with the wider holes in the frame [A] facing outward.

Tighten the screws using an Allen wrench.

④Insert frame [C] into the assembled frame [A, B] and attach it at 4 places using short screws and an hex wrench.