Accessories: Hanger rail set (2 rails, 2 transparent cushions, 2 screws (long / 2 short))

S:double-sided tape ×4, adhesive ×2, magnets ×4

M:double-sided tape ×8, adhesive ×4, magnets ×8

*Accessory contents vary depending on the size.

S： Accessories

Ⅿ： Accessories

Magnets (S: ×4/ Ⅿ: ×8)

How to install

①Position and mount the hanger rail horizontally on the wall.

• If it can be installed on the wall using screws (2 long screws to the wall side)

<aside> ⚠️ When installing on an exterior wall, we recommend that a professional install the product, taking into consideration the material of the exterior wall, where to drill holes, and waterproofing.

(For installers)

• Please install on a wall with a base.

• If you have a plasterboard wall, make sure to attach it to the base behind the wall.

• For concrete, drill pilot holes and use concrete plugs to install.

• The safe load varies depending on the wall material. Please use an installation method that ensures sufficient strength.

• Please select screws, plugs, etc. according to the wall condition and install them based on the judgment of professionals regarding the safety of the installation location. </aside>

• If installation is not possible with screws on the wall (double-sided tape + adhesive)

「Wall surfaces that cannot be fixed with double-sided tape + adhesive:

• Wall surfaces where paint easily peels off
• Wall surfaces that are easily damaged such as wallpaper
• uneven wall surface
• Walls made of materials that are difficult to adhere to, such as rubber, polypropylene, polyethylene, and vinyl chloride.
• Concrete wall (double-sided tape may soften and peel due to the ingredients contained in concrete)

②Attach the hanger rail to the back of the plate with double-sided tape and adhesive

*Depending on the desired installation orientation (vertical or horizontal), change the rail mounting position in relation to the plate and install horizontally, balancing the left and right sides.

*Rail installation is recommended at 5 cm from the top.

<aside> ⚠️

Precautions when applying

*Wipe off oil, moisture, dirt, etc. from the surface to be pasted and let it dry.

*The double-sided tape is pressure-sensitive. Attach the hanger rail and apply sufficient pressure from above.

*The initial adhesive strength of the tape will be lower in low-temperature environments. (15°C ~ recommended)

*It takes about 1 day for the tape to reach its maximum adhesive strength. Let it sit for 24 hours before hanging it on the wall.

</aside>

③Attach transparent cushions to the bottom of the back of the plate in two places on the left and right sides.