Main Body : Steel Frame , logo plates

Frame Accessories : 2 screws, 2 cushion seals

Logo Plate Accessories : 2 strips of strong double-sided adhesive tape

logo plates (with and without printing)

2 pieces of strong adhesive double-sided tape

Precautions before installation

<aside> ⚠️ Professional installation is recommended to consider wall material and proper drilling locations.

(For purchasers)

• To ensure safe use we recommend periodic inspections and installer inspections once a year. Over time deterioration and loosening of the bolts and screws may occur. If any defects are found, please repair or replace parts.

(For installers)

• Please install it where there is a base.
• If you have a plasterboard wall, make sure to attach it to the base behind the wall.
• For concrete, drill pilot holes and use concrete plugs to install.
• The safe load varies depending on the wall material. Please use an installation method that ensures sufficient strength.
• Please select screws, plugs, etc. according to the wall condition and install them based on the judgment of professionals regarding the safety of the installation location. </aside>

How to install

①Attach two pieces of double-sided tape to the round indentations at the top. After peeling off the backing, affix the logo plate. (Press firmly for about 30 seconds.)

②Apply cushion stickers to the bottom two locations on the back of the plate.

※Please install it to the red circled place in the following picture.

③ Measure the horizontal and then drive two screws into the solid wall.

※ Please align the screws with the hole positions on the back side of the steel base (hole spacing: 385mm）