Body: LED Light Add-On

Accessories: 2 hooks, 2 screws, 2 magic tape stickers

*Hooks will be delivered in the same color as the product.

1 LED option (S) or (M)

Hook x 2, Screw x 2, Magic tape sticker x 2

<aside> ⚠️

About the recommended mobile battery

• Please provide a mobile battery that can connect via USB Type-A (rated output current: 2A).
  • A-FRAME Stand Sign: 20,000mAh recommended (Approx. 7 hours of illumination time)
  • ROUND Stand Sign: 10,000mAh recommended (Approx. 7 hours of illumination time)
• Size requirements for attachable mobile batteries
  • A-FRAME Stand Sign: Width 100 × Height 250 × Thickness 15mm or smaller
  • ROUND Stand Sign: Width 100 × Height 130 × Thickness 13mm or smaller </aside>

<aside> ⚠️

Use in case of rain

• Under the eaves is recommended in case of rain
• During inclement weather, please remove the entire hook from the sign and move it indoors to prevent the USB cable and mobile battery from getting wet. </aside>

How to install

①Screw hooks into two locations on the back of the LED option

<aside> ⚠️

Installation Precautions

If the bolt is tightened too much, it may sink into the resin part of the hook and begin to free-spin.

1. Hold the hook firmly in place.
2. Tighten the bolt slowly.
3. Stop tightening just before the bolt begins to sink into the resin.

Following the above steps will help prevent damage and ensure safe assembly.

</aside>

Align the holes of the hook with the holes on the back side.

Tighten the screws with a screwdriver.

②Peel off the release paper from the Velcro and stick it to the back of the LED option and the mobile battery

*It is recommended to attach the hook on the battery side.

*Please adjust the number of sheets to be attached depending on the size and weight of the mobile battery.

![Remove the red release paper.

](https://prod-files-secure.s3.us-west-2.amazonaws.com/7de74224-aa2a-4fbc-935c-cf505409e5a5/1f1ef143-819b-4b2b-a75a-817fd3914119/IMG_5276_(1).jpg)

Remove the red release paper.

hook: Attached on the battery side loop: Attached on the LED option side

Using 1 sheet: Paste in the center (see the blue part of the image) Using 2 sheets: Paste vertically to match the width of the mobile battery (see the red part in the image)

③Attach the mobile battery to the main body of the LED option with Velcro