Body: Frame SET (frame body, push rim, 4 long screws, 3 short screws) Accessories：Cushion seal x 8

*Cushion seals are used only on metal and acrylic plates.

Cushion sticker x 8 *Not for use on wood plates

Precautions before installation

<aside> ⚠️ Professional installation is recommended to consider wall material and proper drilling locations.

(For purchasers)

• To ensure safe use we recommend periodic inspections and installer inspections once a year. Over time deterioration and loosening of the bolts and screws may occur. If any defects are found, please repair or replace parts.

(For installers)

• Please install it where there is a base.
• If you have a plasterboard wall, make sure to attach it to the base behind the wall.
• For concrete, drill pilot holes and use concrete plugs to install.
• The safe load varies depending on the wall material. Please use an installation method that ensures sufficient strength.
• Please select screws, plugs, etc. according to the wall condition and install them based on the judgment of professionals regarding the safety of the installation location. </aside>

How to install

①Place 4 cushion stickers on each edge of the frame and the push edge.

*Frames should be affixed to the recesses of the edges and push edges should be affixed to the flat surface of the frames.

*In the case of wood plate, it is not necessary to apply the cushion seal.

Apply cushion tape in four places in the depression (hole side) on the edge of the frame.

Apply 4 cushion tapes on the flat surface of the push edge.

② Insert the plate with the rimmed side (red part) toward the back.

Assembly image