Body : Steel plate (pre-assembled)

Accessories : Edge tape × 1, Rubber tape × 2, Hex wrench × 1

From left to right: rubber tape×2, hex wrench×1, edge tape×1

How to install

①Remove the red backing paper and attach two rubber tapes to the bottom surface (the surface that touches the ground) of the steel plate

②Cover and fit the transparent edge tape over the protrusion on the inside of the steel plate

※Please cover the red part in the figure below with one part.

③Complete.

※If the bar on the handle becomes loose※

Tighten the screws with the included hex wrench.