Main Unit: Nameplate only (square, rectangular, or pillar-style) Accessories: 2 strips of heavy-duty double-sided tape for construction materials, 1 tube of adhesive

■ Pre-installation checks

*Depending on the material of the installation surface, installation using the included double-sided tape may be difficult. *Please be sure to review the important notes before considering installation.

<aside> ⚠️

Wall Surfaces Not Suitable for the Included Double-Sided Tape and Adhesive

The included double-sided tape and adhesive should not be used on the following surfaces:

• Uneven or textured walls
• Wallpaper or other delicate surfaces that may be damaged or where paint may peel off
• PVC (vinyl chloride) surfaces*(Plasticizers in PVC may reduce the adhesive strength over time.)*
• Surfaces made of rubber, polypropylene (PP), polyethylene (PE), or other low-adhesion materials
• Surfaces with fluorine or silicone coatings, which are difficult for adhesives to bond to
• Concrete walls*(Components in concrete may soften the adhesive tape and cause it to lose adhesion.)*
• Plaster walls (including stucco and traditional lime plaster) </aside>

■Installation Instructions

*To prevent the unit from falling, please use both the tape and the adhesive for installation.

① Wipe away any dirt, moisture, or oil from the bonding surface and let it dry thoroughly.

<aside> ⚠️

• Before installation, thoroughly clean the mounting surface by removing any dust, dirt, oil, or grease, and allow it to dry completely.
• For stone, tile, or other surfaces that may be dusty or powdery, wipe the surface with water first and allow it to dry completely before installation.
• Although the adhesive can be applied in low temperatures, installation is recommended when the ambient temperature is 15°C (59°F) or higher for optimal adhesion.
• If installing on an exterior wall, be sure to wipe the surface with water before installation. Fine dust or sand on the wall may reduce the adhesive's bonding performance. </aside>

② Affix the tape to the back of the nameplate in a balanced manner, leaving the backing paper attached.

For square shapes, please apply the tape vertically as shown in the diagram above.

For long-format envelopes, please apply the tape horizontally as shown in the diagram above.

③Please apply the adhesive in dots at a minimum of four locations, ensuring the resulting layer is thicker than double-sided tape.

④Peel off the backing paper, apply it to the desired location, and press down firmly for about 30 seconds. Since it takes approximately 24 hours to cure, we recommend temporarily securing it with masking tape to prevent it from falling off.

②Remove the temporary holding tape after it has fully cured.

<aside> ⚠️

Important Installation Notes

• When positioning the sign, temporarily secure it only on areas without printed text. Do not use masking tape or painter's tape.
• Applying masking tape over the printed lettering may cause the text to peel off when the tape is removed.
• Once the adhesive has fully cured, the sign will be difficult to remove. Please ensure the position is correct before installation and proceed with this in mind. </aside>